2008 Toyota Prius

Brake pipe corroded, covered in grease or other material front and rear (1.1.11 (c))

Front Drive shaft joint worn, but not excessively both side (6.1.7 (c) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Play in steering rack inner joint(s) both side ()

Front Suspension arm pin or bush worn but not resulting in excessive movement both arm inner bush (5.3.4 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced front to rear (6.1.1 (c) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Fuel Pipe/s corroded ()

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material front and rear (1.1.11 (c))

Front Drive shaft joint worn, but not excessively both side (6.1.7 (c) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Play in steering rack inner joint(s) both side ()

Front Suspension arm pin or bush worn but not resulting in excessive movement both arm inner bush (5.3.4 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced front to rear (6.1.1 (c) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Fuel Pipe/s corroded ()

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Drive shaft joint worn, but not excessively both side (6.1.7 (c) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both arm (5.3.4 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced front to rear (6.1.1 (c) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Fuel Pipe/s corroded ()

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. both side (1.4.2 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Service brake binding but not excessively both side (1.2.1 (f))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Drive shaft joint worn, but not excessively both side (6.1.7 (c) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both arm (5.3.4 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced front to rear (6.1.1 (c) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Fuel Pipe/s corroded ()

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. both side (1.4.2 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Service brake binding but not excessively both side (1.2.1 (f))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Suspension arm pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front anti roll link dust cover slightly damaged

Rear both side sills and suspension mounting areas corroded

Rear exhaust has slight leak

under vehicle covered in under seal

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Suspension component corroded but not seriously weakened all/ mounting areas corroded (5.3.3 (b) (i))

Front both side cv boot slightly deteriorated

Nearside Front windscreen wiper slightly worn

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front anti roll link dust cover slightly deteriorated

Rear both side brake back plate corroded

Rear brake pads slightly worn low

Rear radius arm bush worn

both side suspension mounting area slightly corroded

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear radius arm bush slightly worn

both side sills and suspension mounting area corroded

Coil spring corroded all (5.3.1 (b) (i))

Nearside front and rear tyre slightly worn low

Rear brake discs and brake back plates corroded

Rear brake pads slightly worn low

Rear suspension mounting area slightly corroded

Front Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Offside Front windscreen wiper slightly worn

Rear Service brake fluctuating, but not excessively both side (1.2.1 (e))

Rear axel bush slightly worn

Offside Front cv boot slightly damaged

Rear suspension arm bush slightly worn

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both side (5.1.2 (b) (i))

Rear suspension mounting area slightly corroded

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both side (5.1.2 (b) (i))

Rear suspension mounting area slightly corroded

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive Both sides (5.3.6 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

nearside front tyre worn low

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS