2008 Toyota Aygo

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Headlamp switch does not immediately illuminate all dipped beam headlamps (4.1.3 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Exhaust silencer slightly loose (8.1.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive general area around axle (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Service brake excessively binding both sides (1.2.1 (f))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Headlamp switch does not immediately illuminate all dipped beam headlamps (4.1.3 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Exhaust silencer slightly loose (8.1.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive general area around axle (5.3.6 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting area (5.3.6 (a) (i))

rear axle surface corosion

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting area (5.3.6 (a) (i))

rear axle surface corosion

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear axle has surface corrosion.

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Both front brake discs lipped and worn

Child seat fitted near side rear

Front subframe and rear axle corroded

Near side rear no.plate light inop

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Both front brake discs lipped and worn

Child seat fitted near side rear

Front subframe and rear axle corroded

Near side rear no.plate light inop

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear rear brake binding (3.7.B.1)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Brakes imbalanced across an axle (3.7.B.5b)

advise front tyres worn on inner edge.

Offside Rear Stop lamp not working (1.2.1b)

exhaust blowing and rattling

n/s/r tyre wall perishing

o/s/f tyre has sidewall dam

o/s/r tyre wall perishing

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)