2005 Fiat Ducato

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis leg (5.3.6 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Exhaust has a minor leak of exhaust gases downpipe cracked and slight blow (6.1.2 (a))

Suspension spring mounting prescribed area is corroded but not considered excessive both front inner wings rusted at suspension mounting area (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced both front chassis rusted at inner wings (6.1.1 (c) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Anti-lock braking system component excessively damaged abs ring broken on driveshaft (1.6 (e))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis holed at front corner (6.1.1 (c) (i))

Subframe mounting prescribed area excessively corroded significantly reducing structural strength both front chassis outriggers holed at subframe mounting area (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases downpipe cracked and slight blow (6.1.2 (a))

Suspension spring mounting prescribed area is corroded but not considered excessive both front inner wings rusted at suspension mounting area (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced both front chassis rusted at inner wings (6.1.1 (c) (i))

Exhaust mounting defective (6.1.2 (a))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Direction indicator slightly discoloured both (4.4.3 (a))

Exhaust mounting defective front silencer mounting rubber split (6.1.2 (a))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Vehicle structure is corroded but structural rigidity is not significantly reduced both front chassis rusted (6.1.1 (c) (i))

both front inner wings rusted

spare tyre flat and valve stem split

Front Vehicle structure is corroded but structural rigidity is not significantly reduced cross member (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced chassis front cross member rusted (6.1.1 (c) (i))

both front inner wheel arches rusted and weak

both front wiper rubbers starting to split

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Exhaust mounting defective tailpipe mounting split (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced chassis front cross member rusted (6.1.1 (c) (i))

both front inner wheel arches rusted and weak

both front wiper rubbers starting to split

Offside Front wheel bearing getting noisey

front and rear exhaust mountings cracked

high level stop lamp not working

slight oil leak from engine

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front constant velocity joint is insecure (2.5.C.1b)

Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.B.7)