2008 Toyota Aygo

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Position lamp not working both (4.2.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii)) DANGEROUS

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Inner wheel arch corroded not considered excessive

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre worn close to legal limit/worn on edge on minimum standard (5.2.3 (e))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Shock absorber has slight corrosion to the casing both (2.7.2a)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Electronic power steering warning lamp indicates a failure in the system (2.3.8)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Front Shock absorber has slight corrosion to the casing both (2.7.2a)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pipe excessively corroded to rear (3.6.B.2c)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Nearside Stop lamp not working (1.2.1b)

Offside Front Brake pipe excessively corroded to rear (3.6.B.2c)

front brake application uneven (3.7.B.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

engine mil light on

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

engine mil light on

engine mil light on.

Nearside Stop lamp not working (1.2.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

engine mil light on.

engine mil light on.

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)