2008 Toyota Aygo

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced under seal corroded (5.3.3 (b) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Windscreen damaged and affecting the driver's view of the road (3.2 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner wheel arch (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Both inner sills corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Gained access to boot from inside of vehicle

General corrosion underneath of vehicle

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive Outer sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill corroded (7.1.1 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill corroded (7.1.1 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

unable to check offside rear wheel bearing

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outer sill (6.2.2 (d) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outer sill (6.2.2 (d) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Brake pipe excessively corroded offside front to rear (3.6.B.2c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Registration plate lamp not working both (1.1.C.1d)

Offside Front constant velocity joint is slightly worn (2.5.C.1b)

Offside Front Headlamp aim too low (1.8)