2008 Kia Picanto

Emissions unable to be completed (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases flexi section (6.1.2 (a))

Exhaust has a major leak of exhaust gases rear section (6.1.2 (a))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting by axle (6.2.2 (d) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security by axle (6.2.2 (d) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases front section by flexi (6.1.2 (a))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced n/s and o/s inner sills (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Rear Service brake excessively binding n/s and o/s (1.2.1 (f))

Exhaust has a minor leak of exhaust gases front section by flexi (6.1.2 (a))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced n/s and o/s inner sills (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases flexi section (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Service brake binding but not excessively n/s and o/s (1.2.1 (f))

Front Tyre worn close to legal limit/worn on edge n/s and o/s (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Service brake binding but not excessively n/s and o/s (1.2.1 (f))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil filter leaking

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Exhaust system insecure (6.1.2 (a))

Nearside Front Anti-lock braking system component excessively damaged reluctor ring (1.6 (e))

Nearside Front Upper Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Offside Front Upper Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Oil filter leaking

Exhaust brackets after broken

Offside Front Strut top has play in

Exhaust brackets after broken

Offside Front Strut top has play in

Offside Headlamp aim too high (4.1.2 (a))

Brake pipe excessively corroded Both front to rears (1.1.11 (c))

Fuel tank leaking (6.1.3 (b) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Position lamp not working (4.2.1 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Both strut tops have play in

Front pads are worn close to limit

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Both strut tops have play in

Front pads are worn close to limit

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Headlamp aim too low (1.8)

Offside Stop lamp not working (1.2.1b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Shock absorber has an excessively worn bush (2.7.4)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Shock absorber has an excessively worn bush (2.7.4)