2003 Vulcan Custom

Drive chain worn but not considered excessive slight rusting (6.1.7 (c) (i))

wiring around handle bars loose and unshielded

Fuel cap ineffective (6.1.3 (b) (i))

Drive chain worn but not considered excessive slight rusting (6.1.7 (c) (i))

wiring around handle bars loose and unshielded

Drive chain slightly loose (6.1.7 (c) (i))

Front wheel bearings have excessive free play (2.3.5b)

Headlamp aim too low and too far to the right. (1.6)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Brake pedal is inoperative (3.1.3c) DANGEROUS

exhaust and stand have low ground clearance may cause danger cornering

Brake locking device insecure rear brake cable front split pin (3.2.A1e)

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Throttle has a significant change in engine speed whilst moving the steering from lock to lock (2.1.4)

Throttle operating incorrectly (6.2.1f)

exhaust and stand have low ground clearance may cause danger cornering

Front Front mudguard insecure (2.3.7)

Front Handlebar deformed (2.1.1b)

Rear Brake pedal is positioned so that the brake cannot be readily applied (3.1.3c)

Rear Exhaust is leaking and excessively noisey (7.1.1b)

Direction indicators affected by the operation of another lamp (1.5.1c)

Drive chain excessively loose (6.2.1d)

Headlamp aim too low (1.6)

Headlamp dipped beam affected by the operation of another lamp (1.2.2c)

Horn is not a constant note (1.7.3c)

Rear position lamp adversely affected by the operation of another lamp (1.1.3b)

Rear suspension bearing has excessive free play (2.4.A2a(i))

Stop lamp affected by the operation of another lamp (1.3.2)

Rear suspension bearing has slight free play (2.4.A2a(i))

Direction indicator affected by the operation of another lamp (1.5.1c)

Headlamp switch faulty (1.2.4)

Headlamp switch insecure (1.2.4)

Horn is not a constant note (1.7.3c)

Indicator switch insecure (1.5.4)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear position lamp adversely affected by the operation of another lamp (1.1.3b)

Stop lamp affected by the operation of another lamp (1.3.2)

Rear suspension bearing has slight free play (2.4.A2a(i))

Front Brake pipe excessively damaged (3.2.B2a)

Front Tyre not fitted in accordance with side wall instruction/s (4.1.2e)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear suspension component loose (2.4.A.1a)