2004 Toyota Land Cruiser

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear vehicle structure covered in underseal

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear vehicle structure covered in underseal

Offside Front Headlamp aim too high (4.1.2 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced body mounting (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Brakes imbalanced across an axle brake disc warped (1.2.1 (b) (i))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust has a major leak of exhaust gases MIDDLE BOX CORRODED HOLED (6.1.2 (a))

Front Registration plate inscription illegible (0.1 (b))

Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced BODY MOUNTING CORRODED HOLED (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge 2.4 MM TREAD. PUNCTURED AND WORN ON BOTH EDGES. (5.2.3 (e))

Exhaust has a minor leak of exhaust gases MIDDLE/ BACK BOX HOLED (7.1.2)

Front registration plate faded but not likely to be misread (6.3.1d)

Nearside Battery insecure (1.9.1)

Nearside Front Lower Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front front brake binding BEARING NOT CHECKED (3.7.B.1)

Offside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords IN TREADS. SIZE 255/65/17 (4.1.D.1a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases MIDDLE/ BACK BOX HOLED (7.1.2)

Front registration plate faded but not likely to be misread (6.3.1d)

Anti-roll bar rubber bush deteriorated resulting in excessive movement both D bushes (2.4.G.2)

Central Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Horn not working (1.6.2a)

Nearside Front Inner Front constant velocity joint gaiter missing (2.5.C.1a)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear Rear fog lamp not working (1.3.2b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front suspension has slight play in a lower suspension ball joint both (2.5.B.1a)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

rear exhaust silencer carroded

Brake pipe excessively corroded (3.6.B.2c)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear fog lamp not working (1.3.2b)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

rear exhaust silencer carroded

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)