2006 Toyota Aygo

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Front Registration plate inscription illegible damaged (0.1 (b))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front bumper insecure

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

engine oil level low

general corrosion under side of the vehicle

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Seat belt cut but not affecting the operation of the belt (5.2.2a)

eng/man lamp on

Offside Front Tyre worn close to the legal limit very worn inner edge (4.1.E.1)

Offside Rear Seat belt cut but webbing not significantly weakened (5.2.2a)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)