2008 Toyota Aygo

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Exhaust mounting defective front mount snapped (6.1.2 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Exhaust mounting defective front mount snapped (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps both sides (4.7.1 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension arm corroded but not seriously weakened rear axle beam corroded (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension arm corroded but not seriously weakened rear axle beam corroded (5.3.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Headlamp insecure (4.1.1 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp insecure (4.1.1 (c))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Battery insecure but not likely to fall from carrier Battery carrier loose (4.13 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. Imbalance to service brake, OSR lower efficiency than NSR. Advise investigation. (1.2.1 (b) (i))

Offside Rear Imbalance to handbrake efficiency, OSR low. Advise investigation.

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Emissions not tested Emissions not tested due to major leak of exhaust gases from rear silencer (8.2.1.2 (d))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases Rear silencer split along seam (6.1.2 (a))

Battery insecure but not likely to fall from carrier Battery carrier loose (4.13 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. Imbalance to service brake, OSR lower efficiency than NSR. Advise investigation. (1.2.1 (b) (i))

Offside Rear Imbalance to handbrake efficiency, OSR low. Advise investigation.

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Vehicles internal headlight adjuster altered to recheck lights ()

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Headlamp aim too low (1.8)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)