2012 Toyota Hilux

Brake pipe corroded, covered in grease or other material front & rear both sides (1.1.11 (c))

Coil spring worn all coil springs (5.3.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Integral body structure is deformed but structural rigidity is not significantly reduced all around body (6.1.1 (a) (i))

Rear Leaf spring anchor bracket corroded but not seriously weakened both sides (5.3.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security all under neath (6.2.2 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

engine oil leak

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

engine oil leak

front tyres wearing inside edges

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

front tyres wearing inside edges

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Offside Registration plate lamp not working (1.1.C.1d)

Front registration plate faded but not likely to be misread (6.3.1d)

Nearside Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Offside Rear Registration plate lamp not working (1.1.C.1d)