2012 Toyota Hilux

Brake performance unable to be tested Due to suspension failures. (1.2.1 (g))

Emissions unable to be completed Vehicle not safely able to be driven. (8.2.1.2 (d))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Outer Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Body mount corroded and holed. Rear of front arch. (6.2.2 (d) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Inside chassis rail by fuel tank. (6.1.1 (c) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Body mount corroded and holed. Rear of front arch. (6.2.2 (d) (i))

Offside Rear Leaf spring fractured (5.3.1 (b) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Excessively corroded and holed from engine bay to rear leaf spring mount. (6.1.1 (c) (i))

Offside Rear Leaf spring anchor bracket insecure to the extent that relative movement is visible Completely separated from vehicle. (5.3.1 (a) (ii)) DANGEROUS

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive Shock mounting. (5.3.6 (a) (i))

Nearside Rear Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive Shock mounting. (5.3.6 (a) (i))

Offside Rear Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Underseal has been applied to heavily to fully inspect chassis in certain areas

Vehicle structure is corroded but structural rigidity is not significantly reduced All of vehicle underside. (6.1.1 (c) (i))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

heavely undersealed

under body corrossion

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

under seal under jeep covering

Front position lamp(s) not working (1.1.A.3b)

Stop lamp not working non of them are working (1.2.1b)

Offside Front tyre worn on the inside edge

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Offside Front tyre worn on the inside edge

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Rear fog lamp not working (1.3.2b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)