2013 Fiat 500

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Windscreen wiper does not clear the windscreen effectively n/s o/s (3.4 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

Rear axle showing signs of corrosion

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Brake pad(s) less than 1.5 mm thick both front (1.1.13 (a) (ii)) DANGEROUS

Rear Registration plate insecure but not likely to fall off (0.1 (a))

chip on screen zone A less than 10mm

Front Suspension arm pin or bush excessively worn both sides rear bush (5.3.4 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

chip on screen zone A less than 10mm

near side front day running light inop