2008 Toyota Aygo

1 of 4 high rise stop lights inop

steering slightly tight in straight ahead position

vehicle underside and components dry and showing corrosion in places

Nearside Front Track rod end modification unsafe locking device split pin missing (2.1.3 (f) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

1 of 4 high rise stop lights inop

steering slightly tight in straight ahead position

steering slightly tight in straight ahead position

vehicle underside and components dry and showing corrosion in places

Headlamp light source and lamp not compatible both headlamps (4.1.4 (c))

Nearside Rear Seat belt anchorage prescribed area is inadequately repaired outer sill section (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill section (7.1.1 (a) (i))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner wing section (7.1.1 (a) (i))

Parking brake inoperative on one side very low effort (1.4.1 (a))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both rear axle/subframe mounting areas (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material front to rear at flexi under clip corroded (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Rear Brake pipe corroded, covered in grease or other material front to rear at flexi under clip corroded (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Front Exhaust has a major leak of exhaust gases hanger weld site blowing (6.1.2 (a))

Front Exhaust system insecure hanger weld off (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill in 2 places (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

front pipe exhaust front mounting broken but system still secure.

Nearside Rear Brake pipe excessively corroded section of front to rear (1.1.11 (c))

Offside Rear Brake hose excessively twisted (1.1.12 (b) (ii))

Offside Rear Brake pipe excessively corroded section of front to rear (1.1.11 (c))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

front pipe exhaust front mounting broken but system still secure.

Nearside Front Tyre worn close to the legal limit on limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Rear wheel bearing has excessive play (2.6.2) DANGEROUS