2011 Mitsubishi Outlander

Oil leak, but not excessive (8.4.1 (a) (i))

Headlamp aim too low both (4.1.2 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Brake disc worn, pitted or scored, but not seriously weakened Both front (1.1.14 (a) (ii))

Front brake pads wearing low

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge Outer edge (5.2.3 (e))

Offside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm showing cords (4.1.E.1)

nearside rear tyre wearing on outer edge