2006 MG ZS

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

general under body corrosion

Brake performance not tested (1.2.1 (g))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Front Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

general under body corrosion

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Tyre tread depth below requirements of 1.0mm (4.1.E.2b)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Sill covers fitted preventing inspection of vehicle structure

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Child seat fitted not allowing full inspection of adult belt

Slight bind on N/S front wheel

Slight bind on O/S rear wheel

Could not check outer sills as sill covers fitted

Child seat fitted not allowing full inspection of adult belt

Nearside Headlamp aim too far to the right (1.8)

Offside Headlamp aim too far to the right (1.8)

Child seat fitted not allowing full inspection of adult belt