2010 Toyota Prius

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake disc worn, pitted or scored, but not seriously weakened Both front (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material Both front to rear MAIN (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement wishbone, rear pin/bush (5.3.4 (a) (i))

Service brake fluctuating, but not excessively Both front (1.2.1 (e))

Suspension component mounting prescribed area is corroded but not considered excessive Nearside and offside inner sills (5.3.6 (a) (i))

Suspension spring mounting prescribed area is corroded but not considered excessive Both front, spring turret areas (5.3.6 (a) (i))

Suspension spring mounting prescribed area is corroded but not considered excessive Both rear (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

surface corrosion all under vehicle

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn rear (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn rear (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Headlamp levelling device inoperative Mounting bracket for rear levelling lever broken off of rear axle (4.1.5 (a))

Offside Rear Inner Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Outer Brake pipe excessively corroded (1.1.11 (c))

Centre exhaust hanger broken off of exhaust, exhaust system still adequately supported

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Brake pipe slightly corroded front to rear at rear (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Inner Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit 2mm (4.1.E.1)

Oil leak timing area ()

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake binding (3.7.B.1)

Offside Brake pipe slightly corroded front to rear at rear (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak timing area ()

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear rear brake binding both (3.7.B.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit on 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit on 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit on 1.6mm (4.1.E.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nail in offside front tyre

Front registration plate delaminated (6.3.1d)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)