2006 Proton Savvy

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Tyre obviously under inflated (5.2.3 (h) (i))

Brake fluid contaminated (1.8 (a))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Horn not working (7.7 (a) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Fuel system component leaking excessively or a risk of fire fuel filter (6.1.3 (b) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Headlamp aim too low (1.8)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake hose slightly deteriorated (3.6.B.4d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside front brake binding (3.7.B.1)

Nearside rear brake binding (3.7.B.1)

Nearside rear brakes release unevenly (3.7.B.4)

Offside Front Lower Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside front brake binding (3.7.B.1)

Rear Stop lamp remains on when the brakes are released (1.2.1e)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake hose slightly deteriorated (3.6.B.4d)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Centre Exhaust system not adequately supported (7.1.1)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.D.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside rear brake binding (3.7.B.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake pedal spongy (3.3.B.1b)

Nearside Headlamp aim too low (1.8)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Offside Rear wheel bearing has excessive play (2.6.2)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Brake pedal actuating linkage has excessive wear in the eye of the clevis joint (3.3.A.1g) DANGEROUS

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

front tyres worn uneven and close to limit

rear wiper blade deteriorated

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)