2007 Mazda Bongo

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill holed (6.1.1 (c) (i))

Offside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (rear) (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Exhaust silencer insecure (8.1.1 (b) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (rear) (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Little reserve parking brake travel

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Position lamp showing white light to the rear light lens damaged (4.2.3 (a) (ii))

Offside Front Hydraulic brake calliper leaking and braking performance affected (1.1.16 (b) (ii)) DANGEROUS

Offside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Little reserve parking brake travel

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Reverse lights not working

Nearside Front Brake inadequately mounted Flexi brake hose (1.1.21 (c))

Offside Front Brake hose excessively chafed (1.1.12 (b) (ii))

Offside Front Brake inadequately mounted Flexi brake hose (1.1.21 (c))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated upper and lower (5.3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated upper and lower (5.3.4 (b) (i))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Steering wheel covering slightly insecure

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill panel (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings under sill panel corroed marked with chalk (6.1.B.2)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear rear brake excessively fluctuating (3.7.B.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Offside Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Suspension arm has slight play in a ball joint (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

both front bottom ball joint boots split.

both front wipers starting to separate. rear section exhaust blow.

front brake pads starting to get low.

Parking brake lever has little reserve travel (3.1.6b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Inner Rear Brake pad(s) wearing thin (3.5.1g)

Offside Inner Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside Rear fog lamp missing (1.3.2a)

Rear fog lamp switch missing (1.3.1a)

Nearside Inner Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Inner Rear Brake pad(s) wearing thin (3.5.1g)