1995 Suzuki SJ410

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Windscreen washer not working (3.5 (a))

Front Windscreen wiper not working (3.4 (a))

Nearside Front Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch near steering box mounting x3 (5.3.6 (a) (i))

Nearside Front Track rod end ball joint has excessive play poss x2 (2.1.3 (b) (i))

Nearside Rear Brake cable damaged (1.1.15 (a))

Nearside Rear Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill to floor (5.3.6 (a) (i))

Offside Rear Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength body mounting (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch next to fuel filler (5.3.6 (a) (i))

Central front prop to tranfur box very worn

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive body mounting (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Steering box has seepage (2.1.1 (e) (i))

Offside Front swivle hub weaping

Offside Rear Fuel Pipe/s corroded ()

Nearside Front swivle hub seal leaking

Nearside Front wing corroded

Oil leak, but not excessive sump in a very poor condition corroded and pourous, sealer or some other resin type covering sump (8.4.1 (a) (i))

Body mounting fixings insecure front body to chassis mountings loose n/s and o/s (6.2.2 (c) (i))

Floor excessively deteriorated n/s rear floor to chassis mounting corroded (6.2.4 (a) (i))

Offside Front Floor excessively deteriorated body to chassis mounting floor (6.2.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake pipe excessively corroded axle brake pipes (1.1.11 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake has no recorded effort at a wheel both o/s and n/s leaking , o/s brake no brake effort foot or hand (1.2.1 (a) (ii)) DANGEROUS

Oil leak, but not excessive sump in a very poor condition corroded and pourous, sealer or some other resin type covering sump (8.4.1 (a) (i))

All 4 tyres perished & cracked

Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak ()

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Exhaust has part of the system excessively deteriorated (7.1.1a)

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Stop lamp not working (1.2.1b)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Centre Exhaust system not adequately supported (7.1.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Front Headlamp aim beam image kick up to the offside (1.6.B1)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)