2006 Lexus IS250

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front bumper slightly damaged

REAR DRIVER'S BUMPER SLIGHTLY OUT OF PLACE

Emissions unable to be completed (8.2.2.2 (e))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front bumper slightly damaged

REAR DRIVER'S BUMPER SLIGHTLY OUT OF PLACE

Electronic stability control warning lamp indicates a fault (7.12 (e))

Front Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Windscreen washer not working (3.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Position lamp not working (4.2.1 (a))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Brake performance not tested (1.2.1 (g))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Position lamp not working (4.2.1 (a))

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Inner Tyre has a bulge, caused by separation or partial failure of its structure wall (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Front position lamp(s) not working side light (1.1.A.3b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nail in nearside rear tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)