1995 Toyota MR2

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

covers fitted front to rear

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Windscreen washer not working (3.5 (a))

Nearside Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Service brake requirements only just met. It would appear that the braking system requires adjustment or repair imbalance (1.2.1 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge close to legal limit (5.2.3 (e))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement strut top (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Rear Brake cable has restricted free movement (1.1.15 (e))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front registration plate character(s) likely to be misread (6.3.4b)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

both front springs very rusty

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Rear rear brake excessively fluctuating (3.7.B.3)

Parking brake lever has no reserve travel (3.1.6b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

both front springs very rusty

front discs lipped and pitted

offside rear stabilizer bar deatached to chassis

rear pads getting low

Nearside Outer Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

all four flexible brake hoses slightly perished

surface corosion of all four brake discs

surface corosion of underside of vehicle on suspension components

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Front front brake grabbing slightly (3.7.A.2b)

Offside Front brake disc slightly pitted (3.5.1h)

Offside Front front brake grabbing slightly (3.7.A.2b)