1996 Rover Mini

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced cill (6.1.1 (c) (i))

underside covered in underseal

all underbody covered in underseal

Requirements only just met. Appears braking system requires adjustment parking brake

under side of vehicle is excessively covered in under seal but seems to be structurally ok in the prescribed area's

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Brake pipe excessively corroded to cylinder (1.1.11 (c))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength plus end of sill (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded to cylinder (1.1.11 (c))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength plus end of sill (5.3.6 (a) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Fuel pipes corroded

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced inner wing (6.1.1 (c) (i))

Fuel Pipe/s corroded ()

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Outer sill holed outside prescribed area.

Outer sills corroded.

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Fuel Pipe/s corroded ()

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Outer sill holed outside prescribed area.

Outer sills corroded.

Central Front Oil leak ()

Offside Front Tyre worn close to the legal limit perished and slight wall damage on the outside edge (4.1.E.1)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Side repeater not working (1.4.A.2c)

Emissions not tested (7.3.A.1)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Brake pipe slightly corroded front to rear (3.6.B.2c)

osf floor welded from inside

Bonnet cannot be secured in the closed position (8.4.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Fuel system component leaking filter at rear (7.2.3)

Nearside Front Lower Ball joint has excessive play (2.2.B.1f)

Nearside Front Wheel nut(s) loose (4.2.A.1e)

Nearside Front Wheel stud(s) missing (4.2.A.1e)

Nearside Headlamp aim too low (1.8)

Nearside Subframe mounting prescribed area is inadequately repaired sill (2.4.A.3)

Nearside rear brake binding (3.7.B.1)

Nearside rear parking (secondary) brake grabbing severely (3.7.B.6b)

Offside Front Lower Ball joint has excessive play (2.2.B.1f)

Offside Front Subframe mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Headlamp aim too high (1.8)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Road wheel fixings not compatible (4.2.B.2)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Direction indicator not working (1.4.A.2c)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

rear battery wire loose

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

rear battery wire loose

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear fog lamp not working (1.3.2b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)