2004 Mazda Bongo

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Nearside Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting cross member (6.1.6 (i) (i))

Offside Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch (6.2.2 (d) (i))

Offside Rear Outer Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill to chassis (6.2.2 (d) (i))

Rear fog lamp missing (4.5.1 (a) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front cross member corroded

Nearside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security wheel arch (6.2.2 (d) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive rerar chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Anti-roll bar attachment bracket/mounting damaged and seriously weakened (5.3.3 (b) (i))

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Fuel system component leaking (7.2.3) DANGEROUS

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases back box (7.1.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Subframe mounting prescribed area is excessively corroded cross member (2.4.A.3)

Offside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

front brake application uneven (3.7.B.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases back box (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brakes imbalanced across an axle (3.7.B.5b)

Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded cross member (2.4.A.3)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Inner Seat belt anchorage prescribed area is excessively corroded arch (5.2.6)

Offside Rear Inner Vehicle structure excessively corroded within 30cm of towbar mounting arch (6.6.6)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside front brake binding (3.7.B.1)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear fog lamp tell tale not working (1.3.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

fog lamp built into offside rear reflector

Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings WELDING LOTS (6.1.B.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

front tyres deteriorating

offside sill corroded

park brake efficiency low

rear inner wheel arches slightly corroded

Nearside Front Headlamp not working on dipped beam (1.7.5a)