2009 Mazda Bongo

Emissions not tested too smokey keep voiding results (8.2.2.2 (e))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Power steering component leaking at rack (2.1.5 (a))

Front Tyre slightly damaged/cracking or perishing both tyres (5.2.3 (d) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Macpherson strut mounting damaged but not seriously weakened top mount perishing (5.3.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Upper Macpherson strut mounting damaged but not seriously weakened top mount perished (5.3.3 (b) (i))

Offside Front electric window inop

Offside Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front panel (5.3.6 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside rear brake binding (3.7.B.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill area (2.4.A.3)

coolant leak at front of engine area.

front discs in poor condition.

o/s sill rotten

Power steering component(s) leaking STEERING RACK (2.3.3b)

Fuel system component leaking (7.2.3)

Power steering component(s) leaking (2.3.3b)

Rear fog lamp emits a light other than red (1.3.2e)

Power steering ram(s) has slight seepage from a component (2.3.3b)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Power steering ram(s) leaking from a failed seal (2.3.3b)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

water leak at engine

both front anti-roll drop links gaiters split.

n.s.f steering rack gaiter weeping,

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

both front anti-roll drop links gaiters split.

n.s.f steering rack gaiter weeping,

Nearside Headlamp aim too low (1.8)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Lower Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not working (1.1.5c)

Offside Rear fog lamp missing (1.3.2a)

Rear fog lamp switch missing (1.3.1a)

Rear fog lamp tell tale not working (1.3.1b)

SMALLER TYRES FITTED TO REAR AND NOT FRONT