2005 Mazda Bongo

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced SILL (6.1.1 (c) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded X2 (5.3.1 (b) (i))

Light corrosion to both inner steps/sills

Inner Body has slight corrosion sills (6.1.B.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Power steering ram(s) has slight seepage from a component (2.3.3b)

nsf tyre worn on outer shoulder

Offside Power steering component(s) has slight seepage from a seal (2.3.3b)

front and rear brake disc corroded

Offside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Side repeater not working (1.4.A.2c)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front Registration plate lamp not working (1.1.C.1d)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside All position lamps not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake: efficiency below requirements (3.7.C.1b)

Rear rear parking brake recording little or no effort (3.7.B.6a)

Exhaust has a minor leak of exhaust gases (7.1.2)