2007 Mazda Bongo

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Suspension component mounting repair covered in underseal rear chassis/sills and floor (5.3.6 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength Inner Sill Corroded (5.3.6 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Seat belt not functioning as intended (7.1.2 (c))

Offside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength Inner Sill Corroded (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced within 30cm of rear seat mounts both sides (6.1.1 (c) (i))

Offside Front Battery insecure and likely to fall from carrier tray rotten (4.13 (a) (ii))

Offside Front Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Central Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Rear fog lamp switch not operating in accordance with the requirements (4.5.3 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength o/s inner and outer sills (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inside edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear fog lamp insecure (1.3.2a)

Rear fog lamp not working (1.3.2b)

Nearside Front Headlamp aim too high (1.8)

Service brake: efficiency below requirements (3.7.B.7)

ADVISE/ EXHAUST BLOW FROM CENTER FLEXY PIPE.

ADVISE/ BOTH FRONT TYRES ARE WORN ON BOTH EDGES OF TREAD.

Exhaust has a major leak of exhaust gases (7.1.2)

Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Rear registration plate missing (6.3.1a)

ADVISE/ NEARSIDE HEADLAMP IS BRIGHTER THAN OFFSIDE HEAD LAMP/ REAR EXHAUST SECTION HAS PERFORATED PIPE/ NEARSIDE REAR TYRE HAS CRACKING ON OUTTER SIDEWALL/ FRONT AND REAR TYRES ARE DIFFERENT SIZES.

ADVISE/ OFFSIDE FRONT ANTIROLL BAR LINK ARM TOP JOINT DUST BOOT IS SPLIT./ BOTH REAR TYRES ARE DIFFERENT SIZE TO BOTH FRONT TYRES.

Exhaust emits excessive smoke or vapour of any colour (7.4.B.4)

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

offside and nearside front under sill holed out side perscribed area