2004 Mazda Bongo

Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced front cross member holed and corroded (6.1.1 (c) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced holed and corroded within 30cm of towbar mounting (6.1.1 (c) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill holed and corroded (6.1.1 (c) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced holed and corroded within 30cm of towbar mounting (6.1.1 (c) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner chassis holed and corroded (6.1.1 (c) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill holed and corroded (6.1.1 (c) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill holed and corroded (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material all brake pipes (1.1.11 (c))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

steering rack has slight play in a mounting

underbody covered

Parking brake efficiency below requirements (1.4.2 (a) (i))

underbody covered

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

n/s/f inner sill corroded

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake lagging in operation oil leaking on to brakes (1.2.1 (d))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

n/s/f inner sill corroded

Rear Coil spring corroded Both (5.3.1 (b) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Oil leak ()

Rear brake disc modified but not seriously weakened (3.5.1n)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Rear fog lamp not working (1.3.2b)

Rear fog lamp switch faulty (1.3.1a)

Rear fog lamp tell tale not working (1.3.1b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Oil leak ()

Rear brake disc modified but not seriously weakened (3.5.1n)

Horn not working (1.6.2a)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Rear fog lamp not working (1.3.2b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

N/s and o/s inner sills corroded outside prescribed area.

Power steering component(s) has slight seepage from a component (2.3.3b)

Front and rear brake discs are very corroded

Front support beam for rad is very corroded

Oil leak from steering system

Underside of vehicle has extensive corrosion outside perscribed areas

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

front brake binding (3.7.B.1)

rear brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Horn not working (1.6.2a)

Nearside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Statutory seat belt missing (5.1.1)

Nearside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Statutory seat belt missing (5.1.1)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Statutory seat belt missing (5.1.1)

Offside Rear fog lamp not working (1.3.2b)

Brake pad(s) wearing thin (3.5.1g)

above avises are corroded and holed

at time of test rear seatbelts in boot missing so the following item not failures when belts fitted they become failures. 1 o/s/r crossmember 2 nearside cross member 3 o/s/r inner wheel arch 4 n/s/r inner wheel arch

rear seats and seta belts have been removed

Horn not working (1.6.2a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Front Lower Suspension arm insecure (2.4.G.1)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Stop lamp not working (1.2.1b)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

offside rear driveshaft seal leaking

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

offside rear driveshaft seal leaking

all tyres worn on inner and outer edges

nearside front sill to floor rusty and holed

offside front sill to floor rusty and holed

Rear Exhaust has a major leak of exhaust gases (7.1.2)

all tyres worn on inner and outer edges

nearside front sill to floor rusty and holed

offside front sill to floor rusty and holed

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Side repeater insecure (1.4.A.2b)

Offside Rear brake disc contaminated by oil (3.5.1h)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Side repeater insecure (1.4.A.2b)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Power steering ram(s) has slight seepage from a component (2.3.3b)