2003 Kia Sorento

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Brake pipe corroded, covered in grease or other material offside and nearside (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced sills corroded (6.1.1 (c) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Sub-frame corroded and seriously weakened holes both offside and nearside (5.3.3 (b) (i))

Offside Rear Inner Integral body structure has excessive corrosion which adversely affects braking or steering hole in sill (6.1.1 (c) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material offside and nearside (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced sills corroded (6.1.1 (c) (i))

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front tyres wearing on inner edges

Front Brake pad(s) wearing thin (3.5.1g)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear inner anti roll bar bushes slight worn

Sill skirts fitted , cannot inspect outer sills

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear inner anti roll bar bushes slight worn

Sill skirts fitted , cannot inspect outer sills

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

steel brake pipes starting to rust

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

steel brake pipes starting to rust