1995 Fiat Coupe

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Indicator tell tale inoperative (1.4.A.2a)

Nearside Front Subframe mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Front brake caliper securing device loose (3.5.1j)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner arch panel (2.4.A.3)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Front Seat belt anchorage prescribed area is excessively corroded sill/floor (5.2.6)

Offside Headlamp aim too high (1.8)

Offside Rear Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner arch panel (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Stop lamp not working offside/nearside (1.2.1b) DANGEROUS

Nearside Front head lamp image poor

Nearside Front suspension has slight play in a lower suspension ball joint borderline pass/fail (2.5.B.1a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement inner forward (2.4.G.2)

Offside Front floor/sill corroded and holed outside of 30cm sub frame mount

Offside rear of floor pan corroded and holed

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Sub-frame synthetic bush deteriorated but not resulting in excessive movement offside/nearside bush body corroded and holed (2.4.G.2)

both rear wheel arch slightly corroded

inner sills corroded

relay box insecure hanging down driver side !!!!!!!!!!!!!!!!!!!!!!!!!!

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Passenger seat(s) missing at time of test

Battery insecure (1.9.1)

Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Passenger seat(s) missing at time of test

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Centre Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too far to the left (1.8)

Nearside Outer Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake hose twisted (found during steering lock to lock check) (2.2.D.2b)

Offside Headlamp aim too high and too far to the left. (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Inner Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Brake hose slightly chafed (3.6.B.4d)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Rear Tyre worn close to the legal limit (4.1.E.1)

Steering column top bearing slightly worn (2.1.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Rear seat and rear seatbelts have been removed to house after market stereo equipment

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Rear seat and rear seatbelts have been removed to house after market stereo equipment

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

ns rear tyre tread distorting

os rear tyre tread distorting

Emissions not tested (7.0)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.C.1b)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc slightly pitted (3.5.1h)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

rear brakes low

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Registration plate lamp not working (1.1.5c)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)