2004 Mazda Bongo

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Front Brakes imbalanced across an axle 67% (1.2.1 (b) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill holed (6.1.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill holed (6.1.1 (c) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Centre inner sill holed (6.1.1 (c) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Centre outer sill holed (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill holed (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill inner arch holed (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill holed (6.1.1 (c) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Centre inner sill holed two places close to each other (6.1.1 (c) (i))

Offside Rear Anti-roll bar pin or bush excessively worn Bottom bush worn (5.3.4 (a) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner arch holed also close to seatbelt mounting (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill holed (6.1.1 (c) (i))

Offside Rear Integral body structure is fractured and structural rigidity is significantly reduced Chassis leg corroded cracked weakened (6.1.1 (a) (i))

Rear Service brake excessively fluctuating Very bad fluctuating due to excessive rust on discs (1.2.1 (e))

Front Brake disc worn, pitted or scored, but not seriously weakened Very rusty and pitted (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened Rusty and pitted (1.1.14 (a) (ii))

Windscreen damaged but not adversely affecting driver's view Chip in screen (3.2 (a) (i))

Nearside Front Inner Body has slight displacement of the body relative to the chassis Exes under seal (6.1.B.1a)

Nearside Front Lower Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside Lower Inner sills to floor execs under seal

Offside Front Lower Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Rear Close to limit

Central Front Lower Vehicle structure has excessive corrosion which adversely affects braking or steering cross panel (6.1.A.1)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Nearside Front Outer Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings arch (6.1.B.2)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Front Outer Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings arch (6.1.B.2)

Registration plate lamp not working (1.1.C.1d)

Coolant leak ()

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Rear Tyre worn close to the legal limit both (4.1.E.1)

Rear Vehicle structure has slight corrosion (6.1.A.1)

Centre Front Lower Body has slight corrosion cross member has signs of rust (6.1.B.2)

Nearside Front Lower Vehicle structure has slight corrosion outer sill (6.1.A.1)

Nearside Lower Vehicle structure has slight corrosion inner sill (6.1.A.1)

Offside Lower Vehicle structure has slight corrosion Inner sill (6.1.A.1)

Offside Lower Vehicle structure has slight corrosion outer sill (6.1.A.1)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Subframe mounting prescribed area is excessively corroded cross member (2.4.A.3)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear tyre low on tread on inner edge

front brake pads low

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Offside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp aim too low (1.8)

Registration plate lamp not working (1.1.C.1d)

both rear wheel arches corroded

front anti-roll bar drop links all grease boots split

tested in damp conditions

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp not in good working order (not working) (1.2.4a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

ABS not fitted to this vehicle

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Headlamp aim too low (1.8)

Offside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)

ABS not fitted to this vehicle

Centre silencer repaired with sealant previously.

offside front tyre scrubbing inside edge

offside rear tyre getting low

offside wiper blade split but still effective

poor image offside headlamp

rear anti roll bar link rubbers getting perished

rear exhaust box showing some signs of corrosion

rear number plate laminates getting separated