1995 Toyota MR2

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Oil leak, but not excessive sump (8.4.1 (a) (i))

Rear Tyre worn close to legal limit/worn on edge both tyres (5.2.3 (e))

Emissions not tested overheating (8.2.1.2 (d))

Nearside Front Macpherson strut pin or bush excessively worn internal (5.3.4 (a) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Macpherson strut pin or bush excessively worn internal (5.3.4 (a) (i))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Power steering component leaking rack (2.1.5 (a))

Rear Tyre worn close to legal limit/worn on edge both tyres (5.2.3 (e))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Emissions not tested due to co being to high and blanking gas machine (8.2.1.2 (d))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength at strut top (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength at strut top (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Emissions not tested due to co to high and blanking of machine (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Parking brake lever has little reserve travel (3.1.6b)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Parking brake lever has little reserve travel (3.1.6b)

lower engine bay offside metal brace excess corrosion

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp aim too far to the right (1.8)

lower engine bay offside metal brace excess corrosion

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside front brake binding (3.7.B.1)