1996 Nissan Almera

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill. (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill. (5.3.6 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Lower Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Lower Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre obviously under inflated (5.2.3 (l))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Emission control equipment obviously defective lambia and c/o to high (8.2.1.1 (a))

Nearside Front Emission control equipment obviously defective (8.2.1.1 (a))

Nearside Front Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Body seal corroded

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Body seal corroded

Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

offside rear tyre going out of shape

Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

patch repairs to rear sill areas

Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

patch repairs to rear sill areas

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Headlamp not in good working order (not working) (1.2.4a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)