2006 Mazda Bongo

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside inner and outer sill heavily corroded but not excessively

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Prop shaft joint so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside inner and outer sill heavily corroded but not excessively

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Headlamp lens slightly defective Both (4.1.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Headlamp lens slightly defective Both (4.1.1 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

inner and outer sills heavily corroded

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

inner and outer sills heavily corroded

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive top mount (5.3.6 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive top mount (5.3.6 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Offside Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Euro headlamp masks fitted at the time of test

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Child Seat fitted not allowing full inspection of adult belt ()

Nearside Front Door corroding

Nearside Front Tyre perished and worn on edges

Nearside Outer Sill corroded and holed

O/S & N/S inner sills corroding at centre

O/S & N/S outer sills corroding

Offside Front Tyre perished and worn on edges

Offside Rear Tyre approaching wear bars

Oil leak ()

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Rear Chassis legs and floor pan heavy surface corrosion

Rear Exhaust corroded and deteriorating

Towbar electric socket corroded causing poor connection although all working

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

corrosion nearside and offside chassis

corrosion nearside and offside sills

corrosion nearside rear wheel arch

corrosion offside rear wheel arch

front brake pads worn nearside

unable to test nearside front seat belt due to child seat fitted

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.C.1b)

corrosion offside rear wheel arch

front brake pads worn nearside

corrosion nearside and offside sills

corrosion nearside rear wheel arch

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

corrosion nearside and offside chassis

unable to test nearside front seat belt due to child seat fitted

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp tell tale not working (1.3.1b)

Offside Front Suspension arm locating pin insecure (2.4.G.3a) DANGEROUS

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Headlamp aim too high (1.8)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Rear Parking brake lever has no reserve travel (3.1.6b)

Child seat fitted not allowing full inspection of adult belt

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Oil leak

headlamp aim adjusted during test

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)