1995 Jaguar Xjs

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Brake warning device not identifying low pressure (1.1.4 (a) (ii))

Nearside Front Oil leaking excessively from engine onto front brake (8.4.1 (a) (i))

Nearside Front Windscreen washer not working (3.5 (a))

Nearside Rear Rear reflector missing (4.8.2 (a) (ii))

Nearside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Brake hose bulging under pressure leaking (1.1.12 (d))

Offside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brakes imbalanced across an axle by more than 50% Axle 1 (1.2.1 (b) (ii)) DANGEROUS

Offside Front Brake hose leaking on a hydraulic braking system (1.1.12 (c) (ii)) DANGEROUS

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Front Brake pipe excessively corroded caliper pipes (3.6.B.2c)

Offside Front Direction indicator not working (1.4.A.2c)

Rear registration plate missing (6.3.1a)

Windscreen washer provides insufficient washer liquid not working (8.2.3)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)