2007 Mazda Bongo

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

front cross member

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Road wheel fixing loose wheelnuts fitted incorrectly (5.2.1 (a) (i))

Nearside Rear Anti-roll bar pin or bush excessively worn d'bush (5.3.4 (a) (i))

Nearside Rear Position lamp lens seriously defective (4.2.1 (b))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Anti-roll bar pin or bush excessively worn d' bush (5.3.4 (a) (i))

Offside Rear Seat belt missing buckle missing (7.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front headlamp lens in poor condition

front cross member corroded

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Oil leaking excessively from engine engine (8.4.1 (a) (i))

Rear Exhaust has a major leak of exhaust gases silencer (6.1.2 (a))

Rear Vehicle structure excessively corroded within 30cm of towbar mounting x member (6.1.6 (i) (i))

Nearside Rear Towbar with an unsafe modification to primary components chassis mounting welded and not bolted (6.1.6 (g) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced x member (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity (4.2.3 (b) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced inner and outer sills corroded and holed (6.1.1 (c) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner, outer, sills and inner arch (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill end (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer not working (3.5 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill end (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Windscreen in such a condition that visibility through swept area is seriously affected (3.2 (c) (ii)) DANGEROUS

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Body has slight corrosion inner sill (6.1.B.2)

Offside Rear coil spring corroded (2.4.C.1b)

Oil leak engine ()

Parking brake lever has little reserve travel (3.1.6b)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

unable to carry out full inspection of adult rear seat due to being incomplete

Central Exhaust has a major leak of exhaust gases centre box (7.1.2)

Nearside Front Anti-roll bar has excessive play in a ball joint link (2.4.G.2)

Nearside Rear Anti-roll bar has excessive play in a ball joint link (2.4.G.2)

Offside Rear Anti-roll bar has excessive play in a ball joint link (2.4.G.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill (6.1.B.2)

Offside Rear Body has slight corrosion inner sill (6.1.B.2)

Offside Rear coil spring corroded (2.4.C.1b)

Oil leak engine ()

Parking brake lever has little reserve travel (3.1.6b)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

unable to carry out full inspection of adult rear seat due to being incomplete

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear position lamp(s) incorrect colour (1.1.A.3e)

Offside Front Windscreen wiper blade insecure (8.2.2)

Offside Rear Rear fog lamp emits a light other than red (1.3.2e)

Offside Rear Stop lamp not working (1.2.1b)

NSFbrake hose clip missing

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)