1998 Jaguar Xj

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear All direction indicators slightly discoloured (4.4.3 (a))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Emissions not tested (8.2.1.2 (d))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Anti-lock braking system wheel speed sensor missing (1.6 (c))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill front and rear (6.1.1 (c) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Windscreen washer not working (3.5 (a))

Nearside Front Outer Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Inner Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Suspension spring mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Fuel pipe/s corroded

Nearside Rear Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Rear Parking (secondary brake) grabbing slightly (1.3.1 (c))

handbrake requires adjustment

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

handbrake requires adjustment

Engine covers fitted obscuring some components in the engine bay

Fuel pipe/s corroded

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Engine covers fitted obscuring some components in the engine bay

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Oil leak

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Engine covers fitted obscuring some components in the engine bay

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Oil leak

Fuel pipe/s corroded

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Oil leak

front tyres wearing on inner edges

windscreen has damage outside of swept area

Fuel pipe/s corroded

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen cracked severly outside the swept area.

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Fuel pipe/s corroded

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen cracked severly outside the swept area.

Nearside Front Brake hose slightly damaged (3.6.B.4d)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear wheel bearing has slight play (2.6.2)

Nearside Front Brake hose twisted (3.6.B.4c)

Nearside Front Upper Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear wheel bearing has excessive play (2.6.2)

Nearside Front Brake hose slightly damaged (3.6.B.4d)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear wheel bearing has slight play (2.6.2)

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

offside rear brake hose has a slightly corroded ferrel