1998 MG Mgf

Nearside Rear Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Tyre slightly damaged/cracking or perishing n/s/f & o/s/f & n/s/r (5.2.3 (d) (ii))

Underbody Corrosion

Bonnet primary retaining device slightly deteriorated (3.1 (c))

Front Tyre slightly damaged/cracking or perishing O/S & N/S (5.2.3 (d) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Bonnet primary retaining device slightly deteriorated (3.1 (c))

Front Tyre slightly damaged/cracking or perishing O/S & N/S (5.2.3 (d) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Main beam tell-tale not working (4.9.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake pipe likely to become detached or damaged chalked area (1.1.11 (d) (ii))

Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel both sides (1.3.1 (a) (i))

Rear Service brake excessively binding both sides (1.2.1 (f))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Track rod end ball joint has slight play both sides (2.1.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sills both sides (6.2.2 (d) (i))

Sub-frame corroded and seriously weakened repair not fully welded (5.3.3 (b) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Track rod end ball joint has slight play both sides (2.1.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Battery insecure (1.9.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a major leak of exhaust gases nearside tail pipe broken off (7.1.2)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Rear Direction indicator adversely affected by the operation of another lamp (1.4.A.2h)

Nearside Rear Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Nearside Rear Suspension component mounting prescribed area is inadequately repaired outer sill (2.4.A.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside rear brake excessively fluctuating (3.7.B.3)

Offside Rear Direction indicator adversely affected by the operation of another lamp (1.4.A.2h)

Offside Rear Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is inadequately repaired outer sill (2.4.A.3)

Offside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside rear brake excessively fluctuating (3.7.B.3)

rear brake binding (3.7.B.1)

Front Sub-frame repaired, but not inappropriately (2.4.A.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1a)

OSR LIGHT CLUSTER CRACKED NOT SHOWING WHITE LIGHT TO REAR WHEN PRESENTED FOR TEST

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Offside Front Headlamp aim too low (1.8)

OSR LIGHT CLUSTER CRACKED NOT SHOWING WHITE LIGHT TO REAR WHEN PRESENTED FOR TEST

Brake pipe excessively corroded (3.6.B.2c)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too high (1.8)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Brake master cylinder fluid close to minimum level (3.6.G.1e)

Metal coolant pipe leaking slightly o/s underside

Brake pedal anti-slip provision loose (3.3.A.1b)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Clutch pedal rubber missing

Corrosion to front to rear metal brake pipe

Corrosion to front to rear metal coolant pipes.

Corrosion to o/s/r metal brake pipe.

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Wiper blades in poor condition

Front Brake pipe slightly corroded (3.6.B.2c)

Brake pedal anti-slip provision missing (3.3.A.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Nearside Rear brake disc excessively pitted (3.5.1h)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper blade deteriorated (8.2.2)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear brake disc excessively pitted (3.5.1h)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)