2004 Mazda Bongo Friendee

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area fractured significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

both inner sills corroded but outside of prescribed areas

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

corrosion not in a prescribed area rear inner sills + o/s/r inner wheel arch

corrosion not through all skins inner + outer sills

n/s/r bumper damaged

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

offside front and nearside rear tyres splitting on outer sidewalls

rear bumper damaged and slightly loose

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cross member (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Towbar excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Towbar slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

offside front and nearside rear tyres splitting on outer sidewalls

rear bumper damaged and slightly loose

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

both rear inner lower quarter panels rusty

front cross member rusty

inner and outer sills rusty

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Subframe mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

both rear inner lower quarter panels rusty

front cross member rusty

inner and outer sills rusty

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Nearside Front Lower Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Nearside Front Upper Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Under-trays fitted obscuring some underside components

offside head light poor beam pattern

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Parking brake lever has little reserve travel (3.1.6b)

Front brake disc slightly pitted (3.5.1h)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear brake disc slightly pitted (3.5.1h)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear brake disc contaminated by oil (3.5.1h)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front brake disc slightly pitted (3.5.1h)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear brake disc slightly pitted (3.5.1h)

Brake performance not tested (3.7.A.1)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc excessively pitted (3.5.1h)

Nearside Rear brake disc contaminated by grease (3.5.1h)

Parking brake: efficiency below requirements (3.7.C.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc excessively pitted (3.5.1h)

Service brake: efficiency below requirements (3.7.C.1a)

Spare tyre flat

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

corrsions in both front and rear cross member in non perscribed area

slight corrsion in both inner sills (not excessive)

Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Stop lamp not working (1.2.1b)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Outer Front Front constant velocity joint gaiter split (2.5.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

corrsions in both front and rear cross member in non perscribed area

slight corrsion in both inner sills (not excessive)

Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Body has slight corrosion (6.1.B.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Body has slight corrosion (6.1.B.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)