1995 Rover Mini

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm insecurely attached locking nut insecure (5.3.3 (a) (i))

Nearside Front Position lamp not working dipped beam (4.2.1 (a) (ii))

Offside Front Lower Suspension arm ball joint likely to become detached insecure (5.3.4 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Radius Arm Pin (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Driver's seat backrest cannot be secured in the upright position. (6.2.5 (b) (ii)) DANGEROUS

areas of chassis showing corrosion

areas of subframes showing corrosion

both front & n/s/r tyre showing edge wear 165/60/12h

n/s/r radius arm bearing has slight play

o/s seat fixings poor

Offside Front Upper Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt inner (2.4.G.2)

Offside Front seat fixings poor.

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Rear fuel pipes corroded.

rear brake fluctuating, but not excessively (3.7.B.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a minor leak of exhaust gases rear box (7.1.2)

Nearside Front Valve stem slightly damaged (4.1.D.1e)

Offside Front Valve stem slightly damaged (4.1.D.1e)

Oil leak

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

n/s and o/s floor pans damaged under the seat area

n/s/f and o/s/f tyre valves starting to perrish

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Oil leak

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

n/s and o/s floor pans damaged under the seat area

n/s/f and o/s/f tyre valves starting to perrish

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Nearside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

nearside door mirror glass insecure

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Oil leak

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Subframe mounting prescribed area is fractured (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Direction indicator not working (1.4.A.2c)

Offside rear brake binding (3.7.B.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Side repeater not working (1.4.A.2c)

Nearside Stop lamp not working (1.2.1b)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

o/s/f underwing area corroded