1996 Rover Mini

Nearside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Windscreen washer not working (3.5 (a))

Nearside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Steering column top bearing slightly worn (2.2.2 (b))

Welding repairs covered in underseal

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Steering column top bearing slightly worn (2.2.2 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake pedal has insufficient reserve movement (3.3.A.5)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Rear rear brake recording little or no effort both sides (3.7.B.5a)

Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Side repeater not working (1.4.A.2c)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Headlamp aim too low (1.8)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Upper Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)