2006 Mazda Bongo

Rear rear wiper defective

general corrosion underneath

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm pin or bush excessively worn Rear bush (5.3.4 (a) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill/wheel well (6.1.1 (c) (i))

Offside Front Lower Suspension arm pin or bush excessively worn Rear bush (5.3.4 (a) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner/outer sill plus wheel well (6.1.1 (c) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced Central sill (6.1.1 (c) (i))

Nearside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch (6.1.1 (c) (i))

Offside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch (6.1.1 (c) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear inner, outers sill and wheel arch area holed

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Anti-roll bar linkage pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Front registration plate missing (6.3.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill end (2.4.A.3)

Offside Rear Rear fog lamp not working (1.3.2b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Rear fog lamp not working (1.3.2b)

Rear Brake pad(s) wearing thin (3.5.1g)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Rear fog lamp not working (1.3.2b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Front registration plate delaminated (6.3.1d)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)