2004 Ford Freda

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Nearside Rear Vehicle structure has excessive damage seriously affecting its strength within 30cm of a towbar mounting (6.1.6 (i) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front wing corroded

Offside Seat belt webbing slightly damaged or frayed centre (7.1.2 (b) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Suspension component mounting prescribed area is corroded but not considered excessive o/s + n/s chassis (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive sills + outriggers (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension component mounting repair covered in underseal through out underside (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material ALL (1.1.11 (c))

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front wing corroded

Offside Seat belt webbing slightly damaged or frayed center row (7.1.2 (b) (ii))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength by inner wing (5.3.6 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material ALL (1.1.11 (c))

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front wing corroded

Offside Seat belt webbing slightly damaged or frayed center row (7.1.2 (b) (ii))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front to rear both sides integral body structural has repaired and applied sealant

Offside Front Upper wheel arch has sign of corrosion

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Suspension component mounting repair covered in underseal both sides (5.3.6 (a) (i))

Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced cross member /radiator holder (6.1.1 (c) (i))

Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced and outer both sides (6.1.1 (c) (i))

Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both sides (5.3.6 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced both sides (6.1.1 (c) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill backing (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill backing (5.3.6 (a) (i))

Fuel system component leaking (7.2.3)

Fuel system component leaking from engine (7.2.3)

Nearside rear brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded of sill (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

o/s hand brake lower reading

leak on n/s/r hub bearing seal

Battery insecure (1.9.1)

leak on n/s/r hub bearing seal

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has little reserve travel (3.1.6b)

corrosion o/s sill

Offside Headlamp aim too low (1.8)

Parking brake lever has little reserve travel (3.1.6b)

corrosion o/s sill

nsr hub oil leak

Offside Rear Rear fog lamp not working (1.3.2b)

nsr hub oil leak

slight auto trans leak

Offside Front Front position lamp(s) not working (1.1.A.3b)

slight auto trans leak