1995 Peugeot 405

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

fuel filler neck insecure

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Headlamp aim not tested (4.1.2 (b))

Horn not working (7.7 (a) (ii))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

fuel filler neck insecure

Front Sub-frame corroded but not seriously weakened particly around the n/s suspension arm mounting points (2.4.G.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front tyre has minor damage to the sidewall

Park brake has only just met the minimal requirements

Parking brake lever has little reserve travel (3.1.6b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a major leak of exhaust gases multiple spots (7.1.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Suspension arm has excessive play in a pin/bush rear bush (2.4.G.2)

Nearside Rear Stop lamp emits other than a steady red light light cluster smashed (1.2.1e)

Offside Front Suspension arm has excessive play in a pin/bush rear bush (2.4.G.2)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

front fogs not working

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside front brake binding (3.7.B.1)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside front brake binding (3.7.B.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)