1996 Ford Bongo

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Sub-frame corroded but not seriously weakened Surface corrosion. (2.4.G.1)

Front brake disc worn, pitted or scored, but not seriously weakened Both. (3.5.1i)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Oil leaking from half shaft seal at back plate.

Offside Front Tyre worn low on inner tread.

Oil leak ()

Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement Both D bushes. (2.4.G.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings various holes - inner sill (6.1.B.2)

Nearside Front front brake binding (3.7.B.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings various holes - inner sill (6.1.B.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front front brake binding (3.7.B.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Exhaust has a minor leak of exhaust gases rear flexi section (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened x2 (3.5.1i)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear fluid leak at back plate

Offside Front front brake fluctuating, but not excessively (3.7.B.3)

Offside Front tyre worn on inside and outside

Oil leak ()

Rear Anti-roll bar linkage has slight play in a pin/bush nearside and offside (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened x2 (3.5.1i)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement x2 (2.4.G.2)

Front brake disc worn, pitted or scored, but not seriously weakened x2 (3.5.1i)

Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement x2 (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened x2 (3.5.1i)

front cross member has slight corrosion

n/s and o/s sill has slight corrosion

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front crossmember slightly corroded

n/s sill advise slight corrosion

o/s sill advise slight corrosion

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

n/s sill corroded but not seriously weakend

o/s sill corroded but not seriously weakend

Offside Ball joint has excessive play (2.2.B.1f)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside Rear Statutory seat belt missing (5.1.1)

Nearside Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Statutory seat belt missing (5.1.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Headlamp aim too low (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)