1995 Subaru Impreza

Front front and rear brake discs have surface corrosion

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement and offside (5.3.4 (a) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened and offside (5.3.3 (b) (i))

Nearside Rear Suspension rod pin or bush worn but not resulting in excessive movement and offside tie bars (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear brake backing plates corroded both

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Horn not working (7.7 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength within 30 cm of rear suspension mounting inner sill/floor (5.3.6 (a) (i))

Offside Front Brake hose ferrule excessively corroded also has the location clip missing center (1.1.12 (f) (i))

Nearside Front Brake hose has slight corrosion to ferrule and both rear pipes (1.1.12 (f) (i))

Offside Front Brake hose slightly damaged center support location clip missing (1.1.12 (b) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement n/s and o/s have movement (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both have surface corrosion (1.1.14 (a) (ii))

Rear Suspension arm pin or bush worn but not resulting in excessive movement all tie bar bushes perished n/s and o/s (5.3.4 (a) (i))

all brake back plates have deep corrosion

rear suspension arms have deep surface corrosion

car has been under-sealed

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Front registration plate missing (6.3.1a)

Horn not working (1.6.2a)

Offside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Service brake grabbing severely (3.7.C.2)

Stop lamp not working (1.2.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

brake pads front and back will need replacing soon