1996 Mazda Bongo

Emissions unable to be completed (8.2.2.2 (e))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch (7.1.1 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced under sill (7.1.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced under sill (7.1.1 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Windscreen washer not working (3.5 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear leak on axle

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower wheel arch (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower wheel arch (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected out rigger (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Emissions not tested over heating (8.2.2.2 (e))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Body component corroded and likely to cause injury (6.2.1 (a) (i))

Offside Front Suspension component mounting prescribed area is inadequately repaired sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front arch + rear quarter (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Body has slight corrosion (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside front brake binding (3.7.B.1)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Body has slight corrosion (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front front brake binding (3.7.B.1)

Rear Statutory seat belt missing (5.1.1)

Rear Statutory seat belt missing (5.1.1)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Body has slight corrosion (6.1.B.2)

Offside Rear Outer Body has slight corrosion arch (6.1.B.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp aim too low (1.8)

Offside Rear Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Offside Rear Anti-roll bar linkage insecure (2.4.G.1)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Fuel system component leaking (7.2.3) DANGEROUS

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Vehicle structure has slight corrosion (6.1.A.1)

headlight beam patterns poor

Nearside Outer Front Brake pad(s) wearing thin (3.5.1g)

Offside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Outer Front Brake pad(s) wearing thin (3.5.1g)

Offside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Lower Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Outer Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Offside Outer Front Brake pad(s) wearing thin (3.5.1g)

Offside Outer Rear Brake pad(s) wearing thin (3.5.1g)

o/s rear tyre replaced with part worn. on legal limit 1.6mm

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Upper Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Side repeater not working (1.4.A.2c)

Nearside Outer Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Outer Front Brake pad(s) wearing thin (3.5.1g)

Offside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside front parking brake recording little or no effort (3.7.B.6a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

front brake pads low.

slight play n/s/f anti roll bar link arm.

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

oil leak

Rear Rear fog lamp not working (1.3.2b)

Front Brake pad(s) wearing thin (3.5.1g)

Front Headlamp aim too low (1.8)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen washer provides insufficient washer liquid (8.2.3)

oil leak