1995 Toyota Celica

Front Front position lamp(s) not working (1.1.A.3b)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Body has a projection caused by corrosion (6.1.C.1)

Nearside Rear Body has a sharp edge caused by damage (6.1.C.1)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Body has a projection caused by corrosion (6.1.C.1)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Body has a projection caused by damage (6.1.C.1)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear coil spring incomplete (2.4.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe inadequately supported (3.6.B.1)

Battery insecure

Front Shock absorber has slight corrosion to the casing (2.7.2a)

Front coil spring corroded (2.4.C.1b)

Fuel pipe/s corroded

Nearside Rear coil spring corroded (2.4.C.1b)

both rear roll bar bushes slightly worn

front bottom cross member slightly corroded

front brake discs corroded inside edge

n/s/front wing mirror damaged

n/s/r tyre wearing inside edge

rear under car corroded

Nearside Registration plate lamp not working (1.1.5c)

Offside Registration plate lamp not working (1.1.5c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Nearside Rear Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

rear brake application uneven (3.7.B.2)