1996 Rover Mini

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement radius arm (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Lower Suspension arm ball joint excessively worn both sides (5.3.4 (a) (i))

Front Upper Suspension arm ball joint excessively worn both sides (5.3.4 (a) (i))

Headlamp aim too low both sides (4.1.2 (a))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement radius arm (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

slight play in nearside rear radius arm bushes

Exhaust system not adequately supported (7.1.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

slight play in nearside rear radius arm bushes

Front Brake pad(s) wearing thin (3.5.1g)

rear sub frame corroded

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

rear sub frame corroded

Oil leak

offside and nearsiderear tyres wearing on edges

Brake pipe excessively corroded (3.6.B.2c)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Rear Electrical wiring inadequately supported (1.9.2a)

Oil leak

offside and nearsiderear tyres wearing on edges

Oil leak

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Lower Ball joint has excessive play (2.2.B.1f)

Nearside Front Upper Ball joint has excessive play (2.2.B.1f)

Nearside Stop lamp not working (1.2.1b)

Offside Front Lower Ball joint has excessive play (2.2.B.1f)

Offside Front Upper Ball joint has excessive play (2.2.B.1f)

Offside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Oil leak

Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Horn not working (1.6.2a)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Headlamp aim too far to the left (1.8)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear brake binding (3.7.B.1)

rear brake application uneven (3.7.B.2)

rear brakes release unevenly (3.7.B.4)

Excessive corrosion nearside sill front

Offside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Parking brake: efficiency below requirements (3.7.B.7)