2005 Ford Bongo

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember under radiator as marked (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength as marked (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under wheel arch as marked (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under wheel arch 2x places as marked (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength as marked (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired under wheel arch (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear fog lamp insecure (4.5.1 (c) (i))

Front Brake pipe corroded, covered in grease or other material both side (1.1.11 (c))

Offside Front wheel arch corrode

Rear A 7-pin trailer socket not functioning correctly

engine under tray fitted

Nearside Rear Anti-roll bar attachment bracket/mounting insecure (5.3.3 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pipe corroded, covered in grease or other material both side (1.1.11 (c))

Offside Front wheel arch corrode

Rear A 7-pin trailer socket not functioning correctly

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

engine under tray fitted

Brake pedal anti-slip provision missing (1.1.2 (c))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength 30cm to sub frame (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength 30cm to suspension arm (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength 30cm to anti roll bar mount (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength 30cm to sub frame (5.3.6 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength 30cm to suspension arm (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength corroded on top of the coil spring (5.3.6 (a) (i))

Rear Anti-roll bar linkage pin or bush excessively worn both side (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material front and rear (1.1.11 (c))

Nearside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Outer sills damage

Offside Front Windscreen wiper does not clear the windscreen effectively wiper arm loose (3.4 (b) (ii))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both crack (5.2.3 (d) (ii))

Rear both side wheel arch corrode

coolant metal pipe corroded (under the car)

engine under tray fitted

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Central Lower Vehicle structure has slight corrosion nearside inner sill (6.1.B.2)

Central Lower Vehicle structure has slight corrosion offside inner sill (6.1.B.2)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Central Lower Vehicle structure has slight corrosion nearside inner sill (6.1.B.2)

Central Lower Vehicle structure has slight corrosion offside inner sill (6.1.B.2)

Vehicle structure has slight corrosion (6.1.B.2)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Power steering component(s) leaking from a failed joint (2.3.3b)

Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Oil leak

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Exhaust has a minor leak of exhaust gases (7.1.2)

rear brake discs/surface rust

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front to rear signs of surface rust and on components

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front drive shaft coupling flexible rubber or fabric coupling unit breaking up (2.5.C.1d)

Offside Rear fog lamp not working (1.3.2b)

Parking brake lever has no reserve travel (3.1.6b)